Need pictures of 2.7l engine
#1
Need pictures of 2.7l engine
I bought an A6 with a 2.7l, the problem is that all the engine parts down to the head were sitting in the trunk. I am putting it back together now and would like pictures of the wiring and vacuum routing. I need pictures of the top of the motor for installing the intake and correctly running the wires, as well as pictures of the rear of the motor for hose routing for the breather tube and secondary air lines and attaching a couple of small brackets found in the trunk. I am excited to get this car running and finally drive it.
Thank you.
Thank you.
#3
Re: Need pictures of 2.7l engine
You would likely find a Bentley Manual handy for this work! Also there should be a vacuum diagram sticker under the hood.
Here are a few pics that may help out a bit:
Here are a few pics that may help out a bit:
#6
Re: Need pictures of 2.7l engine
You can read the entire document with above pics here:
http://www.vaglinks.com/Docs/Audi/B5...ne_english.pdf
A good read for all 2.7T owners!
http://www.vaglinks.com/Docs/Audi/B5...ne_english.pdf
A good read for all 2.7T owners!
#7
Re: Need pictures of 2.7l engine
These Pictures are great and help a lot, I know where all of the vacuum and wiring go, I just am not sure exactly how each wire and hose is set. Especially the behind the intake, there are a lot of wires and hoses, I just want to make sure I get them how they were originally run. I am about to put the intake manifold on, but I am unsure if the wires and injector harness runs under the intake manifold or on the outsides. Just little things like that. When I bought it everything down to the heads was removed by a mechanic who got sick and all the parts thrown in the trunk and the bolts in a shoe box.
I took the heads off to replace 6 intake valves bent from carbon build up I bought the car for $2400 from a girl who never used premium gas and caused bad carbon build up, enough to slightly (<1mm) bend the 3 upper intake valves on each side just enough to cause them not to seat and loose compression.
I will send pictures of where I am at and the areas I have questions on.
Thank you guys for the help so far I really appreciate it.
I took the heads off to replace 6 intake valves bent from carbon build up I bought the car for $2400 from a girl who never used premium gas and caused bad carbon build up, enough to slightly (<1mm) bend the 3 upper intake valves on each side just enough to cause them not to seat and loose compression.
I will send pictures of where I am at and the areas I have questions on.
Thank you guys for the help so far I really appreciate it.
Thread
Thread Starter
Forum
Replies
Last Post
cameron92
Exterior & Body Mods
13
11-14-2011 03:07 PM
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)