I bought a set of aftermarket headlights, were easy to install. But the only problem is I dont know much about electrical. And in order for the halo's to turn in is if they have some sort of relay, cause there are some loose wire's dangling from the base of the headlight 3 Black and 3 Red, on each light. Do those need to be ran to the battery? Any insight on this please post with any materials/things I would need to purchase...

 

Dude theres only one right way to do it... Contact the manufacturer, get correct wiring diagram or one should have come with the lights themselves ... I would advise not connecting them to a power source until you know 100% what and where to connect, they will never replace them on warranty if you miswire them and they burn out... Get the documentation even if you will get a professional to wire it, they will still need it otherwise your guess is as good as theirs... My 2c
good luck and I hope all will be good, post success pics!
...and how many halos per light enclosure - 3? Then it might be easy... But it's just guessing

 

No wiring diagram came with the lights. But there are 2 halo's in each headlight, I could take more pics if you think that will give you a better understanding of the problem.

 

Here's a pic of what they look like.

 

I would contact the manufacturer for the wiring diag...
If one assumes the wires are pairs (3black 3red) is there any way to differentiate the wires..? Location/connectors/markings/anything..?