Hello

Looking into changing the Blaupunkt RDM169 stereo with a Becker Mexico Pro
or similar radio...
From the brochures I find that the pin-out used for CD-shifters for
Blaupunkt and Becker are not the same.
Some connectors on Becker radios are actually undocumented...

Does anybody now what the correct pin-outs for socket C2/C3 must be if I
try to connect the ancient CDC A05 to the new Becker stereo?

This is the information I have found about sockets C2/C3 by comparing
brochures:

Socket C2, pin 7-9, not listed on Becker, not connected on Blau
Socket C2, pin 10, not listed on Becker, switched +12v to RC on Blau
Socket C2, pin 11, not listed on Becker, RC on Blau
Socket C2, pin 12, not listed on Becker, Ground on Blau
C2 are stated as specific for Becker CDC, but not used for CDC at all on
Blaupunkt.


Socket C3, pin 13, AF telephone input on Becker, Bus-In on Blau
Socket C3, pin 14, Ground telephone input on Becker, Bus-Out on Blau
Socket C3, pin 15, not listed on Becker, not connected on Blau
Socket C3, pin 16, not listed on Becker, switched 12V on Blau
Socket C3, pin 17, not listed on Becker, Bus Ground on Blau
Socket C3, pin 18, CD AF Ground on Becker, AF Ground on Blau
Socket C3, pin 19, CD AF Left (AUX) on Becker, Line In - L on Blau
Socket C3, pin 20, CD AF Right (AUX) on Becker, Line In - R on Blau

Actually if somebody can explain the function of the pin-out not listed
above I would be happy...


regards
Ottar T

--